In the box

• One large panel

• Two small panels

  

Unpacking

<aside> 💡 To prevent scratches during transit, it is recommended that you unbox and install the modesty panels in the actual room where the lectern will be used.

</aside>

<aside> ⚠️ If your large modesty panel includes a custom-printed logo, this artwork may be covered with a protective film. Leave this protective film in place for now.

</aside>

• [ ] Carefully remove three panels of your modesty panel set from its packaging.
• [ ] Rest each panel on a towel or the packaging foam.
• [ ] Remove the masking paper or film from both sides of each panel.

Assembly

<aside> 💡 Standard modesty panels are reversible and the modesty panel spacers can be installed to either panel side.

</aside>

<aside> 💡 The installation hardware for your modesty panel set is included with your H920C Heckler Lectern.

</aside>

• [ ] Press and install a modesty panel spacer into each pill-shaped hole in the panel.

  

• [ ] Fasten each modesty panel thumbscrew through the panel and then through the spacer. The spacer will retain the screw, creating a tool-less panel installation.

  

Installation

• [ ] Grip the top center edge with one hand and lift the panel. Position it to align the screws with the mounting hole positions on the sides of the lectern.
• [ ] With your other hand, tighten each thumbscrew. Gently wiggle the panel as you tighten the thumbscrews to ensure a firm installation.