In the box

  1. 1 x Side Mount
  2. 2 x Mullion-mounting Screw (F063)
  3. 2 x Rubber Washer (F064)
  4. 1 x Set Screw Assembly Key (F914)
  5. 1 x Enclosure Assembly Key (F529)
  6. 1 x Right-angle USB-C to USB-C adapter (F915)
  7. 1 x Cable Tie (F817)
  8. 1 x Velcro dot set

H753-000.jpg

Mount the pocket to your mullion

<aside> 💡 Use the fully assembled Side Mount as your hole template

</aside>

Determine the height of your installation

<aside> 💡 To install the iPad to your mullion at an ADA-compliant height, position the enclosure so that the top edge of the iPad screen is no higher than 48 inches above the finished floor.

</aside>

H753-001.jpg

Mark the mounting holes

Align the front face of the enclosure bezel to the front face of your mullion. Using a felt-tipped marker, mark the two screw positions and the CAT cable hole position as shown. Remove the mount from the mullion.

H753-002.jpg